Autoplugin RCP
is an interface module between Ford factory equipped fuel-fired heater (FFH) and control device. It allows
you to connect almost any convenient remote control to FFH.
Autoplugin RCP uses permanent connection to
vehicle wiring and controls the heater via CAN-bus.
Original Ford button with windscreen or back glass heating logo and built-in LED.
It can be silver or dark gray, with red lighting only. Button is supplied with installation set of wires
specially prepared for use with RCP module.
An additional button may be installed on console for one-touch FFH start / stop, boost mode control and easy settings change.
Button functions:
Heater Start
Heater Stop
One-time boost disable
One-time boost enable
Boost extension (don't let the FFH stop after the engine has been switched off)
Autoplugin RCP
is an interface module between Ford factory equipped fuel-fired heater (FFH) and control device. It allows
you to connect almost any convenient remote control to FFH. 
Silver, windscreen glass heating logo
Silver, back glass heating logo
Graphite, windscreen glass heating logo
Graphite, back glass heating logo